When picking up a mooring, always use the top ring to pick the buoy up with a boat hook. Then shackle the mooring pennant to the mooring chain shackle, rather than to the buoy itself. This puts all the strain on the anchor chain, rather than the buoy.
What Size Buoy Will I Need?
A buoy's size is determined by the weight of the line or chain it must support. Calculate the weight of your line, plus a 25% safety margin, then consult the buoyancy chart on the individual buoy information page.
Always use chafing gear where mooring lines run through bow chocks or are likely to contact deck hardware. A thimble on the shackled end will prevent chafe at the buoy.
What is the Right Size Fender for My Boat?
To find the right size fender for your boat, review the Fender Sizing Guide. Common sense, as well as an understanding of your boat and mooring conditions, must be considered in selecting the right fender.
In a hard blow, the holding power of the mooring can be increased by lengthening the mooring pennant. This increases the scope of the mooring, providing greater holding power - just be sure to check other boats in the moorage first to ensure you won't foul another moored boat.
In adverse conditions, a second mooring pennant can be run to the top eye as a safety in case the primary pennant chafes through or fails.
All shackles should be moused to prevent opening. Electrician's plastic tie wraps are an excellent means of securing a shackle.
Polyform buoys and fenders can be inflated either with the Polyform hand pump or almost any form of compressed air that will cover the valve. An inflation adapter is available for use with standard compression nozzles or hand pumps.
Polyform products are designed to be inflated to 2.1 lbs/0,15 bar of pressure at 68°F/20°C. When inflating without a pressure gauge, fill the buoy or fender until the walls are fully expanded, but make certain you can depress the walls at least 1/4 inch with light hand pressure. Measure the circumference and compare it with the inflation chart for proper pressure. Over inflation will reduce the performance of the product and may cause premature failure. Over inflation voids the warranty.